Russell,
when the idle mixture screw is correctly adjusted, any more than about 1 to 1.5 turns inwards should make the idle uneven (because it's too lean), whereas it should take about 3 or 4 turns out to make it stumble because it's too rich.
Engines are much more sensitive to a weak mixture than a rich one, which is why folk don't tend to notice that their air filter is clogged, until they bother to do an mpg check, that is...
With the 2CV's long inlet tracts, you should wait about 5 seconds after turning the screw to see what effect it's had, since movement of gas through the tracts is slow with the throttle closed and only the idle circuit in operation.
Sean will have the link to a VW video, showing how to adjust the idle on their Solex carbs.
With it warmed up, turn the idle screw inwards until the engine falters, then back about 1/2 to 1 turn.
1/2 is better if you're struggling with the MOT emissions test, so bring the idle speed up a bit to keep it running OK.
Lastly, new barrels and pistons do need to be run in.
Is it too late for this?
http://www.citroentuning.de/doc/How_to_break_in.pdfken
( High CO tends to be mixture too rich, high HC is related to oil getting into the combustion chamber.)
Russell wrote:
Right, so as mentioned my car failed it's mot again on emissions, with 6.5% CO. Nothing I could adjust at the test centre made any difference, and to be honest I am pissing in the wind a bit here. Now, the mixture screw, as I understand it is the one on the front of the carb withthe offset slot? On my car it'd been mangled in and wouldn't screw in more than a few threads and went in pissed. I changed the carb for a random one off the scrap pile/carefully stored spares. I briefly cleaned it out and fitted it, after starting it I tried to adjust the mixture and noticed that I can turn the screw a couple of turns either way and the engine stalls is that normal? Where do I start with this?
Secondly, would the high CO have anything to do with the new rings and pistons etc? Ie, as it's not run in yet I assume it's probably burning a bit more oil than it should, or something...