| Author |
Message |
|
pavlos_k
2CV Fan
Joined: October 10th, 2011, 10:05 pm
Posts: 86
Location: Greece
|
 headlight adjustement bar Guys good morning .
i am trying to adust the headlights. I was thinking that if i put the wings then all will be set in position looking straight ahead.
So yesyerday i installed the wings but nothing got straight.
So is there a tip.? I am thinking that the bar through the years and crashes got bend.
Any tip on how to make headlights looking forward ?
|
| November 26th, 2011, 8:33 am |
|
|
|
J-dub
Aircooled Idiot
Joined: April 24th, 2010, 10:01 am
Posts: 5733
Location: Location Location
|
Re: headlight adjustement bar Are yours looking backwards?
_________________
1988 2cv 652cc
1993 Toyota Hilux Surf 3000cc runs on Bio Diesel
2004 Toyota Landcruiser Amazon 4200cc runs on Bio Diesel
1998 Daihatsu Hijet 1300cc
2005 Susuki Bandit 650cc
|
| November 26th, 2011, 9:58 am |
|
|
|
pavlos_k
2CV Fan
Joined: October 10th, 2011, 10:05 pm
Posts: 86
Location: Greece
|
Re: headlight adjustement bar No but they dont look at the centre of the car . the Bar is closer to the left cylinder than the right one.
|
| November 26th, 2011, 10:09 am |
|
|
|
J-dub
Aircooled Idiot
Joined: April 24th, 2010, 10:01 am
Posts: 5733
Location: Location Location
|
Re: headlight adjustement bar Hmm, without looking at my car I can't give you a answer which is wrong and soon to be corrected by someone  Ken or Sean will be along soon
_________________
1988 2cv 652cc
1993 Toyota Hilux Surf 3000cc runs on Bio Diesel
2004 Toyota Landcruiser Amazon 4200cc runs on Bio Diesel
1998 Daihatsu Hijet 1300cc
2005 Susuki Bandit 650cc
|
| November 26th, 2011, 10:14 am |
|
|
|
Sean
Firing on two.
Joined: April 22nd, 2009, 11:06 pm
Posts: 3684
Location: Ecosse
|
Re: headlight adjustement bar maybe not!
Pavlos unless there has been bits cut out from it then fail to see how it is off.
you may have to be carefull how you attach the wings /fenders as the whole thing is unstable and wobbly untill is all tightened up.
Could just be that the actual light is not central on its ball mount on the end of the bar, loosen the 19mm bolt and swivel it about till you have it how you want it.
_________________
Kissing the Lash
"Any advice of a technical nature is given on the understanding that I've actually done this shit, not just read about it in D*lly club mag some time ago.
|
| November 26th, 2011, 10:26 am |
|
|
|
pavlos_k
2CV Fan
Joined: October 10th, 2011, 10:05 pm
Posts: 86
Location: Greece
|
Re: headlight adjustement bar Guys i ve found it . the horizontal bar was not straight . i took a piece of metal and a pipe wrench and flame heat it , and bend it back.
thanks again guys.
|
| December 2nd, 2011, 9:20 am |
|
|
