|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
beerbunny
2CV Fan
Joined: March 16th, 2011, 7:25 pm
Posts: 48
|
 Removing door panels I'm thinking about removing the door panels so I can spray Waxoyl inside the bottom of the door.
Firstly, is this a good idea?
Secondly, how do I remove the panels; and will I need to replace the fixers, whatever they are?
Thanks.
|
| June 26th, 2011, 11:45 am |
|
|
|
Sean
Firing on two.
Joined: April 22nd, 2009, 11:06 pm
Posts: 3684
Location: Ecosse
|
Re: Removing door panels john end of steel ruler paint scraper etc slipped in under a bottom corner and pull
proper steel spring clips so its not like you'll break the clips
waxoyle of Dinitrol thinned with oil always a good idea but smelly
_________________
Kissing the Lash
"Any advice of a technical nature is given on the understanding that I've actually done this shit, not just read about it in D*lly club mag some time ago.
|
| June 26th, 2011, 12:25 pm |
|
|
|
twofifty AZU
Firing on two.
Joined: May 16th, 2010, 5:04 pm
Posts: 835
|
Re: Removing door panels You can lever the door trims off, Try to ver as near to the hidden clip as possible or you'll break them out of the hardboard. You can feel the clips through the vinyl. It won't allow you to see into the bottom of the door though. You need a thin wand to get anti rust wax into them.
|
| June 26th, 2011, 12:28 pm |
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 154 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
