|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
Removing pedal box/master cylinder
| Author |
Message |
|
panelbeaterpeter
Firing on two.
Joined: April 24th, 2011, 6:05 pm
Posts: 226
Location: Everywhere
|
 Removing pedal box/master cylinder Just a quick one, I'm in the middle of stripping the 2CV, and have come to the pedal box. I've undone the two 14mm bolts holding it to the bulkhead, now does the master cylinder detach from the pedal box, or do I have to take the reservoir off the cylinder and push the whole lot through the hole? The box appears to be held onto the cylinder with flange ended bushes, but maybe I'm having a stupid moment..
_________________
(°\=/°)
1989 2CV6 (what's a D*lly?), 1989 MG 1275 powered mini, Renault Trafic.
|
| June 7th, 2011, 7:27 pm |
|
|
|
Sean
Firing on two.
Joined: April 22nd, 2009, 11:06 pm
Posts: 3684
Location: Ecosse
|
Re: Removing pedal box/master cylinder Pete
yes pull the master reservoir off by pulling it to one side and itll pop out the seals
then the master and the full pedal assembly pulls into the car you have to rock it one way then the other to get the front port through the gap.
Sean
_________________
Kissing the Lash
"Any advice of a technical nature is given on the understanding that I've actually done this shit, not just read about it in D*lly club mag some time ago.
|
| June 7th, 2011, 7:35 pm |
|
|
|
panelbeaterpeter
Firing on two.
Joined: April 24th, 2011, 6:05 pm
Posts: 226
Location: Everywhere
|
Re: Removing pedal box/master cylinder Aha! Nice one, thanks! I was getting hungry so abandoned it, but will have the mother' off tomorrow.
_________________
(°\=/°)
1989 2CV6 (what's a D*lly?), 1989 MG 1275 powered mini, Renault Trafic.
|
| June 7th, 2011, 8:43 pm |
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 367 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
