Joined: April 18th, 2009, 11:43 am Posts: 2424 Location: Meneac, Bretagne France
Gear lever bush
How to? Seen and tried some options. None any good really. I now cut, replace the bushes and weld it again. Heard of an englishman doing this without cutting. Do you know the secret?
Attachment:
lever-002.jpg
Attachment:
lever-001.jpg
You do not have the required permissions to view the files attached to this post. _________________
January 20th, 2011, 3:43 pm
J-dub
Aircooled Idiot
Joined: April 24th, 2010, 10:01 am Posts: 5733 Location: Location Location
Re: Gear lever bush
make a pattern of it / mould, heat it up, bend, remove, replace bushes, push back through, re bend to mould / pattern?
if life was only so simple
_________________
1988 2cv 652cc 1993 Toyota Hilux Surf 3000cc runs on Bio Diesel 2004 Toyota Landcruiser Amazon 4200cc runs on Bio Diesel 1998 Daihatsu Hijet 1300cc 2005 Susuki Bandit 650cc
Users browsing this forum: No registered users and 89 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
