|
|
|
| Author |
Message |
|
Willami
Firing on two.
Joined: January 14th, 2009, 11:44 pm
Posts: 501
Location: West Country, England
|
 Re: Clutch noise when hot. ken wrote: the spigot bearing in the tail of the crankshaft, as well as replacing the tiny oil seal, before fitting the new clutch?
i'm about to replace the clutch on mine - can you tell me what the spigot bearing is and where i need to put the grease exactly - thanks Ken Will
_________________
1970 Volvo 144 (but i still like to see what's going on in A-Series land
|
| January 5th, 2011, 11:16 am |
|
|
|
Sean
Firing on two.
Joined: April 22nd, 2009, 11:06 pm
Posts: 3684
Location: Ecosse
|
Re: Clutch noise when hot. I know you asked Ken
But if you dont mind me crashing the thread...its the hole in the middle of the flywheel depending on age youll have either a plain bronze bearing or a needle roller. A squirt of grease for the needle and the bronze was supposed to sit submerged in oil for a few hours but a squirt of grease wont do it any harm either.
Sean
_________________
Kissing the Lash
"Any advice of a technical nature is given on the understanding that I've actually done this shit, not just read about it in D*lly club mag some time ago.
|
| January 5th, 2011, 11:26 am |
|
|
|
Willami
Firing on two.
Joined: January 14th, 2009, 11:44 pm
Posts: 501
Location: West Country, England
|
Re: Clutch noise when hot. Thanks Sean - okay, I know what you mean by the hole in the flywheel - it's a late 70's M28 - so this is to lubricate where the input shaft sits??? thanks Sean wrote: I know you asked Ken
But if you dont mind me crashing the thread...its the hole in the middle of the flywheel depending on age youll have either a plain bronze bearing or a needle roller. A squirt of grease for the needle and the bronze was supposed to sit submerged in oil for a few hours but a squirt of grease wont do it any harm either.
Sean
_________________
1970 Volvo 144 (but i still like to see what's going on in A-Series land
|
| January 5th, 2011, 12:09 pm |
|
|
|
Sean
Firing on two.
Joined: April 22nd, 2009, 11:06 pm
Posts: 3684
Location: Ecosse
|
Re: Clutch noise when hot. Willami wrote: Thanks Sean - okay, I know what you mean by the hole in the flywheel - it's a late 70's M28 - so this is to lubricate where the input shaft sits???
thanks Yup
_________________
Kissing the Lash
"Any advice of a technical nature is given on the understanding that I've actually done this shit, not just read about it in D*lly club mag some time ago.
|
| January 5th, 2011, 12:20 pm |
|
|
Who is online |
Users browsing this forum: No registered users and 42 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
