International2cvFriends.com - View topic

Page 1 of 1

[ 7 posts ]

Tie rod thread size

Author	Message
French Tickler Joined: August 7th, 2012, 10:33 pm Posts: 16	Tie rod thread size Hi, the thread at the end of the tie rod which screws into the suspension tie rod end eye, has been damaged. I need to cut a new thread to start the thread run off again. To that end, what size is the thread, all my taps & dies sets don't seem to fit. Thanks.
May 23rd, 2015, 9:05 pm

AZL57 Firing on two. Joined: October 22nd, 2014, 10:59 pm Posts: 2223 Location: South-Limburg	Re: Tie rod thread size 11x100 says the 12/18 HP parts catalogue... anyone can confirm if this is also the size for the modern versions?
May 23rd, 2015, 9:54 pm

Russell Firing on two. Joined: November 29th, 2008, 10:05 pm Posts: 9259 Location: West Sussex, U.K.	Re: Tie rod thread size M11x1mm _________________ samfieldhouse wrote: What I like about I2F is that there is no pretence of democracy.
May 23rd, 2015, 10:02 pm

ken Agony Aunt - You have a car problem? Speak to Ken Joined: March 6th, 2009, 1:40 am Posts: 3675	Re: Tie rod thread size 'Same as it ever was'... https://www.youtube.com/watch?v=I1wg1DNHbNU Russell wrote: M11x1mm _________________
May 24th, 2015, 1:28 am

French Tickler Joined: August 7th, 2012, 10:33 pm Posts: 16	Re: Tie rod thread size ken wrote: 'Same as it ever was'... https://www.youtube.com/watch?v=I1wg1DNHbNU Russell wrote: M11x1mm Ouch Ken, Skewered by your rapier like whit. :
May 24th, 2015, 11:38 am

French Tickler Joined: August 7th, 2012, 10:33 pm Posts: 16	Re: Tie rod thread size Russell wrote: M11x1mm Thank you Russell
May 24th, 2015, 11:52 am

French Tickler Joined: August 7th, 2012, 10:33 pm Posts: 16	Re: Tie rod thread size AZL57 wrote: 11x100 says the 12/18 HP parts catalogue... anyone can confirm if this is also the size for the modern versions? thank you AZL57
May 24th, 2015, 11:52 am
Display posts from previous: Sort by

Page 1 of 1

[ 7 posts ]

Tie rod thread size

Who is online