|
|
|
|
Page 1 of 1
|
[ 5 posts ] |
|
| Author |
Message |
|
Boggy
Firing on two.
Joined: October 27th, 2012, 10:45 pm
Posts: 122
Location: Deux Sevres France
|
 Bearings for pedals Hi all
I have a 1965 AZ which I have restored but want to know if the old type pedals, non suspend, should have a bush or bearing where they go through the bulkhead? If so are they available anywhere
Cheers
Boggy
|
| September 24th, 2014, 7:13 pm |
|
|
|
Bart
Firing on two.
Joined: February 12th, 2009, 6:17 pm
Posts: 316
Location: North
|
Re: Bearings for pedals I suppose you mean the standing/flat laying rod pedals? I think on mine there a sort of copper washers in the guide/support on the crossfloor, nothing else. I put a fair bit of grease on the rods to make sure they don't were so much and go smooth, but even that is probably over the top.
_________________
|
| September 26th, 2014, 7:45 pm |
|
|
|
Boggy
Firing on two.
Joined: October 27th, 2012, 10:45 pm
Posts: 122
Location: Deux Sevres France
|
Re: Bearings for pedals yep Bart that is what I am looking for, are they just pressed in?
|
| September 26th, 2014, 11:31 pm |
|
|
|
lpgo
Firing on 1-2 Spark
Joined: November 8th, 2009, 5:42 pm
Posts: 2847
Location: NL
|
Re: Bearings for pedals
_________________
Russell wrote: Hi Geo,
you've been one of the sites biggest attractions in recent years.
Russ
|
| September 27th, 2014, 9:29 am |
|
|
|
Boggy
Firing on two.
Joined: October 27th, 2012, 10:45 pm
Posts: 122
Location: Deux Sevres France
|
Re: Bearings for pedals Cheers Geo
That's it
many thanks
Boggy
|
| September 27th, 2014, 6:09 pm |
|
|
|
|
Page 1 of 1
|
[ 5 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 95 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
