
Re: Track rod end housing
Peter,
the (pair of) holes for the split pin which locks the adjusting screw are mirror imaged, so that they will face towards the front of the car when installed.
That's the only difference between LH & RH housings for 2CVs, Dyane, AZU, etc.
If the supplier has sent out a housing for an Ami, AK350, AKS400 or Acadiane, that would be too long and also is offset/cranked away from the line of the track rod.
A longer shot, but an Ami Super housing has a larger diameter thread for connection to the track adjusting sleeve...
ken
2CViking wrote:
Suffering from CRAFT disease? Are left and right the same?
I think they are? (same for adjusters and track rods?)