O,k Jameswallace, heres the deal, ChrisW is getting a MarkII unit by end of next week.... , when he's satysfied with the new one he will send me back his Mark I, I will update the software and send it over to you (it will take 2 to 3 weeks from now I guess) I will charge you 75 euro as whe agreed you being a testdriver.....

Eh geo

When you are fully satisfied / after your tests etc

could w do some sort of fit up on our Barbour 4x4 's here in Croatia

and may be an exchange of 4x4 parts or cash to suit!!?

the boys down here could benefit from your system which mark has told me really works well on his 4x4
and i would be interested to have one on my 4x4 when it finally gets built!

pony

Sounds good geo

Perfect will no doubt be asking for advice on fitting

I Love to do 4x4s..... youv'e got a deal; how many units for a difflock or 2..????

Well its the same over here, don't have the time to finish my own 4x4. 1-2-spark is absorbing all my sparetime...

I will p.m. you when 1. production batch is ready, I then can send you one so you can "play" with it....

If you want more then we can arange it then.....

I've been thinking more about this a lot lately for my application. Full sequential fuel and spark may be a bit over kill!
Am I correct in thinking this would require 2 standard 2cv coils to be fired as wasted spark, like you have done with your 4 cylinder, cirrect?. Unless you can rig up a cam trigger and make it sequential!
I'll purchase one as soon as it is available, I will advance payment if that helps.

I assume the Ls1 truck coils I have wont work?
http://www.megamanual.com/seq/coils.htm

I am still 3-4 months away from needing the new ignition setup

Harley

Cheers Harley great to have you back, I think the Ls1 coils will work fine on my ignition, I asume you have 4 pieces of them, So I have 4 5 volt triggers so this wouldn.t be a problem.

But first I would try with 1 2cv coil
Then 2 2cv coils and then at last the ls1......

Yesterday I had an event over here, where I demonstrated 1-2-Spark, it was overwelming........ So now I'm going to look if I can get production units as fast as possible....

Hey geo when do you want my money?!

Hope to sent ChrisW his unit middle of this week don't know how long it takes him to install and tune, as soon as he sent me the old one I will sent it to you.... Will give you a pm with banknumbers when I got everything sorted..
bringing it to the latest software standard....

Once version 2 arrives it should take me a couple of hours to change and test - Next weekend is Easter so could be a delay with the post..

Found a nice article about multispark......




http://www.dtec.net.au/Multi%20Spark%20Ignition.htm