St.Marc is also a great product in the US cleaner. I use it always in combination with hot water in the US for clock parts.

Yesterday i replaced the brake discs a lot of taking parts of to reach the discs. All went well, did put in new brakepads too. On the pads i bought at a french supermarket years ago there was an "how to replace your brakepads" advise.... First step take the wheels of the car.....sleep on...

My lockable fuel cap like that on the picture came apart in my hands. The rivets that hold the lock ring to the cover gave way. I tried to rerivet them but it didn't hold. So i drilled in the rivets and tapped M3 in there. I screwed it back together with some locktite. Hope it hold now.

New problem after rebuilding all parts on the car the choke have become very heavy to use. So this evening i got the whole cable out. Took it apart and when i blow trough the outer cable a lot of dust came out. The inner cable was worn in little dimples. Made by the outer cable over the years. So i did rub it down with sand paper. A bit of grease and all put in again. I can move the choke with 2 fingers now.

Passed at the MOT today. All clear i may drive for 2 years again. Nice picture with hanging wheels.

Conratulations !

Thanks. It had a little play on the king pivots. Horizontally ??? Never seen that, normally it's vertically. The lower hole seems to be a bit oval front to rear...

Bought this mouthpiece for my grease gun. It clicks on and there is no leaking grease at the nipple. Works well. only the blue tube is a bit stiff. I used my old one in rubber.

How about a link!

https://www.ebay.de/itm/134977048851
this is only one you have to check out the lowest price. I payed 8,50. There are dozens of offers.

If it might interest someone an other picture off the 2cvs underside at the MOT. Nice dangling wheels.