View unanswered posts | View active topics It is currently March 28th, 2024, 12:11 pm



Reply to topic  [ 339 posts ]  Go to page Previous  1 ... 10, 11, 12, 13, 14, 15, 16 ... 34  Next
 Yellow Dyane 
Author Message
Online
Firing on two.
User avatar

Joined: March 5th, 2009, 6:23 pm
Posts: 2130
Location: Near Monmouth
Post Re: Yellow Dyane
Skilled hero in my book.


May 30th, 2020, 5:46 pm
Profile
Firing on two.

Joined: December 21st, 2014, 7:33 pm
Posts: 866
Location: Rhayader Mid Wales
Post Re: Yellow Dyane
ImageP1030009 by Robndaisy, on Flickr

This is what can happen when 'someone who should know better' uses an out of balance knot twist rotary wire brush without the guard. No cut (lucky for me) and the brush is in the bin. It ripped off the interior sound deadening/ sealer a treat mind :).

ImageP1030013 by Robndaisy, on Flickr

Cutting through, leaving the original piece as something to weld to.

ImageP1030015 by Robndaisy, on Flickr

Now that's out of the way it's easy to trim the outer remnants from the inside.

ImageP1030016 by Robndaisy, on Flickr

Bolted onto the chassis and this is what you want to see, the toeboard panel sitting evenly across. seriously good panels Ken ;) .

ImageP1030020 by Robndaisy, on Flickr

the outer panel, held off by the original pressings, will either flatten then or cut around them for final fixing.

ImageP1030021 by Robndaisy, on Flickr

This repair panel fits well tidy. The front outrigger underneath will have to be replaced.

ImageP1030022 by Robndaisy, on Flickr

The driver's side (nearside, right hand ) is along way from shore though :D.


May 31st, 2020, 7:36 pm
Profile
Firing on two.

Joined: December 21st, 2014, 7:33 pm
Posts: 866
Location: Rhayader Mid Wales
Post Re: Yellow Dyane
ImageP1030036 by Robndaisy, on Flickr

Finally was able to break out the welder and fasten the outer front sill repair that i'd made, permanently :) .
Tomorrow, the inner and maybe the front floor panel, maybe :D .
I'm so slow these days it's pathetic. :roll:


June 12th, 2020, 8:48 pm
Profile
Firing on two.

Joined: December 21st, 2014, 7:33 pm
Posts: 866
Location: Rhayader Mid Wales
Post Re: Yellow Dyane
ImageP1030039 by Robndaisy, on Flickr

modified an axle stand to support the corner of the body while cutting around the the floor outrigger. Hung the door to check gaps ok.

ImageP1030042 by Robndaisy, on Flickr

ImageP1030044 by Robndaisy, on Flickr

ImageP1030045 by Robndaisy, on Flickr

ImageP1030047 by Robndaisy, on Flickr

As far as I got, driver's side almost ready for welding in, and passenger side (which needs a lot of work) started. :)

ImageP1030046 by Robndaisy, on Flickr

The trouble with Daisy being stuck in Portugal is that I have to make my own lunch these days :lol: .


June 13th, 2020, 7:21 pm
Profile
Online
Firing on two.
User avatar

Joined: March 5th, 2009, 6:23 pm
Posts: 2130
Location: Near Monmouth
Post Re: Yellow Dyane
Doorsteps look delicious :D


June 13th, 2020, 7:47 pm
Profile
Firing on two.
User avatar

Joined: March 21st, 2013, 12:04 am
Posts: 1577
Location: Exeter, Devon
Post Re: Yellow Dyane
Coming along nicely :) Better than my painting. :D

You got any mustard? :)

_________________
If you can't fix it with a hammer, it's probably electrical (or, an electric fuel pump!) ....


June 13th, 2020, 11:12 pm
Profile
Firing on two.

Joined: December 21st, 2014, 7:33 pm
Posts: 866
Location: Rhayader Mid Wales
Post Re: Yellow Dyane
ImageP1030053 by Robndaisy, on Flickr

That's the inner piece of the triangular toeboard being welded in thank flame!
welding to decent steel like this is a pleasure, welding to the Citroen 'bean can' steel is usually fizzy but sometimes ok. This is when a Bedouin appeals, 'cos any offcuts could go into the woodstove :D


June 28th, 2020, 7:16 pm
Profile
Firing on two.
User avatar

Joined: March 21st, 2013, 12:04 am
Posts: 1577
Location: Exeter, Devon
Post Re: Yellow Dyane
The way I feel about the Shed sometimes, the whole Bedouin could go in the woodstove. :o

_________________
If you can't fix it with a hammer, it's probably electrical (or, an electric fuel pump!) ....


June 28th, 2020, 9:04 pm
Profile
Firing on two.

Joined: December 21st, 2014, 7:33 pm
Posts: 866
Location: Rhayader Mid Wales
Post Re: Yellow Dyane
ImageP1030064 by Robndaisy, on Flickr

The floors going in, driver's side done, just doing passenger's. Back on the windscreen surround tomorrow, :) .
When bodyshell is flipped, I'll be able to finish closing off the ends of the sills etc. glad that's done, eventually :roll: . Like me, you're probably sick of looking at it :lol:


July 3rd, 2020, 6:20 pm
Profile
Firing on two.
User avatar

Joined: July 10th, 2010, 12:35 pm
Posts: 1091
Location: Magyarország
Post Re: Yellow Dyane
This dyane in your hands makes me think of this song :
https://youtu.be/IQNBQI3UDag

_________________
'T is een kwestie van geduld.........


Ez a türelem kérdése.........


July 3rd, 2020, 7:13 pm
Profile
Display posts from previous:  Sort by  
Reply to topic   [ 339 posts ]  Go to page Previous  1 ... 10, 11, 12, 13, 14, 15, 16 ... 34  Next

Who is online

Users browsing this forum: No registered users and 98 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group.
Designed by STSoftware for PTF.