Author |
Message |
Roger V
Firing on two.
Joined: March 21st, 2013, 12:04 am Posts: 1581 Location: Exeter, Devon
|
Re: World meeting 2019
Are you sure it is fully in 1st gear? What condition are the rubber grommets on the linkage? Under normal driving without the trailer, is 1st gear noisy at all?
_________________ If you can't fix it with a hammer, it's probably electrical (or, an electric fuel pump!) ....
|
August 8th, 2018, 5:11 pm |
|
|
mobylette69
Joined: March 23rd, 2018, 4:26 pm Posts: 27
|
Re: World meeting 2019
Yes linkages look fine..1st gear doesnt sound any noise than usual...Im not sure if there is a thrust bearing issue as there is whine or rattle when I engage clutch
_________________ Instagram @mobylette
|
August 8th, 2018, 6:08 pm |
|
|
AZL57
Firing on two.
Joined: October 22nd, 2014, 10:59 pm Posts: 2007 Location: South-Limburg
|
Re: World meeting 2019
Are the motor and gearbox support rubbers ok?
|
August 8th, 2018, 8:06 pm |
|
|
mobylette69
Joined: March 23rd, 2018, 4:26 pm Posts: 27
|
Re: World meeting 2019
They all look fine, in normal use it never has popped out of gear...maybe it just wasn't in correctly ??
_________________ Instagram @mobylette
|
August 8th, 2018, 8:25 pm |
|
|
EirikJ
Firing on two.
Joined: February 17th, 2009, 8:43 pm Posts: 567 Location: NOrWAY
|
Re: World meeting 2019
Make sure the gearlever doesn't touch anything in the engine compartment when in 1st gear. Or any other gear for that matter....
_________________ Vennlig hilsen, Eirik
Five 2CV's, DS 21 ieh Pallas -70, DS 23 h Pallas -75, CX 25 GTi automatic -89, XM 2,0i -90 And a Heinemann Z412 -80
|
August 9th, 2018, 9:47 am |
|
|
AZL57
Firing on two.
Joined: October 22nd, 2014, 10:59 pm Posts: 2007 Location: South-Limburg
|
Re: World meeting 2019
The edge of the fire wall is dented in the 2cv i don't know if that if the dyane is also.
|
August 13th, 2018, 5:13 pm |
|
|
samfieldhouse
Firing on two.
Joined: February 11th, 2009, 12:32 am Posts: 3324 Location: Chichester, West Sussex
|
Re: World meeting 2019
AZL57 wrote: The edge of the fire wall is dented in the 2cv i don't know if that if the dyane is also. I thought that was only early 602s
|
August 22nd, 2018, 10:11 am |
|
|