|
|
|
| Author |
Message |
|
ChrisW
Firing on two.
Joined: February 21st, 2012, 9:01 pm
Posts: 1136
Location: Avranches, Sud Manche, France
|
 Re: Drive shaft in a tiz But couldn't the pin come out of the arm if its loose
|
| September 16th, 2015, 9:26 pm |
|
|
|
ken
Agony Aunt - You have a car problem? Speak to Ken
Joined: March 6th, 2009, 1:40 am
Posts: 3675
|
Re: Drive shaft in a tiz Not sure why, but from what I've seen, a kingpin which is a loose fit in the arm always moves upwards, never downwards.
If the resultant scraping, graunching noises are ignored for long enough, the pin can grind so much metal off the constant velocity joint's casting that the outer driveshaft needs to be replaced...
_________________
|
| September 16th, 2015, 9:55 pm |
|
|
Who is online |
Users browsing this forum: No registered users and 41 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
