International2cvFriends.com
http://www.international2cvfriends.com/forum/

Aftermarket H style tow bar fitment
http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=986		 Page 1 of 1
Author:  Tim2cv [ November 2nd, 2009, 9:45 pm ]
Post subject:  Aftermarket H style tow bar fitment
hi everyone.
trying to fit an aftermarket H style towbar on the D*lly but having an SLC chassis there are no holes to fit it. where and how far from the end should I fit the tow bar/drill the holes? Russ do you have one on your Slamboo?

cheers

TIM
Author:  ken [ November 2nd, 2009, 10:11 pm ]
Post subject:  Re: Aftermarket H style tow bar fitment
Tim,
offer the assembled tow bar up to the underside of the rear legs, so that the rearmost crossbar is about 10mm in front of the bumper hangers.
Clamp it in place with mole grips, square it up, then deploy the drill with an 10mm bit fitted.
Watch out for hot swarf finding its way up your sleeve, btw... ;)

ken.

Tim2cv wrote:
hi everyone.
trying to fit an aftermarket H style towbar on the D*lly but having an SLC chassis there are no holes to fit it. where and how far from the end should I fit the tow bar/drill the holes? Russ do you have one on your Slamboo?

cheers

TIM
Author:  Tim2cv [ November 2nd, 2009, 10:23 pm ]
Post subject:  Re: Aftermarket H style tow bar fitment
thank ken, so it really is as simple as first thought. the hardest bit will be finding a drill bit thats not blunt!

cheers

TIM
Page 1 of 1 All times are UTC + 1 hour [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/