1
| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| Brake pipe seals....assembly question http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=6310 |
Page 1 of 1 |
| Author: | 48pop [ June 15th, 2020, 1:09 pm ] |
| Post subject: | Brake pipe seals....assembly question |
Rookie order of assembly question...... 1. Does the seal go on to the pipe first then insert into wheel cylinder or 2. Stick the seal into the cylinder, then push in the pipe???? |
|
| Author: | Geert [ June 15th, 2020, 4:54 pm ] |
| Post subject: | Re: Brake pipe seals....assembly question |
I do it as mentioned in 2. But my brother does it as in 1. |
|
| Author: | rob massey55 [ June 15th, 2020, 6:31 pm ] |
| Post subject: | Re: Brake pipe seals....assembly question |
1
|
|
| Author: | Taskos [ June 16th, 2020, 10:14 pm ] |
| Post subject: | Re: Brake pipe seals....assembly question |
1 |
|
| Author: | lpgo [ June 17th, 2020, 5:00 pm ] |
| Post subject: | Re: Brake pipe seals....assembly question |
New seal then 2. Used seal which is already in the hole then also 2. With 1 the seal can go wrong into the hole. |
|
| Author: | rob massey55 [ June 17th, 2020, 5:20 pm ] |
| Post subject: | Re: Brake pipe seals....assembly question |
not if you give the seal enough fish 
|
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|