International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
Oil pressure http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=6308 |
Page 1 of 1 |
Author: | Edce [ June 12th, 2020, 6:10 pm ] |
Post subject: | Oil pressure |
I am curious about the level of oil pressure we can expect in the 2cv engines (602 and 652 cc). I have installed an oil pressure reading gauge. At idle I measure 20 psi (1,2 bar) and at around 4000 rpm, it is 60 psi (4,4 bar). Anybody has same experience ? |
Author: | subarupete [ June 12th, 2020, 7:26 pm ] |
Post subject: | Re: Oil pressure |
From https://www.citroenspecialsclub.org/pub ... /page1.php After starting the car and left to warm up to a steady idle the readings were 115 psi at 6000 rpm 90 psi at 3000 and 50 psi at 1000 I then went on a blast for 1/2 hour reaching 60ish mph. After this the readings were 90 psi at 6000 rpm 60 psi at 3000 rpm, at idle the reading was 20 psi dropping to 15 psi after a couple of minutes. |
Author: | Taskos [ June 16th, 2020, 10:02 pm ] |
Post subject: | Re: Oil pressure |
According to Haynes manual: A79/0 and M4 35.5 to 44 lbf/in2 @4000rpm A79/1 57 to 71 lbf/in2 @6000rpm M28 and m28/1 78 to 92 lbf/in2 @6000rpm |
Author: | Edce [ June 17th, 2020, 8:50 am ] |
Post subject: | Re: Oil pressure |
Thnks Taskos, I have a Visa engine but the values seem to be similar. |
Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |