International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
drummer - handbrake lever pivot http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=6296 |
Page 2 of 2 |
Author: | Geert [ February 27th, 2020, 9:21 am ] |
Post subject: | Re: drummer - handbrake lever pivot |
AZL57 wrote: That's the problem the 2cv is in cms not in inches.... I wished there still where inches, stone, pound sterling ,mph., a milkfloat, the local shop and pub, etc. ,and in Holland the equivalent of that. The world would look much better . |
Author: | 48pop [ February 27th, 2020, 5:21 pm ] |
Post subject: | Re: drummer - handbrake lever pivot |
I measured again, in new fangled centimeters, 8.5.....I need a more reliable tape measure |
Author: | Geert [ February 27th, 2020, 8:06 pm ] |
Post subject: | Re: drummer - handbrake lever pivot |
What is the problem , why is it only 2 ˝ you measure? |
Author: | 48pop [ February 27th, 2020, 9:35 pm ] |
Post subject: | Re: drummer - handbrake lever pivot |
All is good, when I measured it more carefully it was same as yours...... |
Page 2 of 2 | All times are UTC + 1 hour [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |