View unanswered posts | View active topics It is currently April 16th, 2024, 11:31 am



Reply to topic  [ 22 posts ]  Go to page 1, 2, 3  Next
 Miss fire 
Author Message
Firing on two.
User avatar

Joined: March 21st, 2013, 12:04 am
Posts: 1581
Location: Exeter, Devon
Post Miss fire
The Shed's engine miss fires if I just open the throttle a little. It idles nicely, and runs ok once you get past the rough spot. Can't say I've noticed it when driving as I would normally give it more beans.

It has luminition ignition. A Harley type (black) coil.

Any thoughts!

_________________
If you can't fix it with a hammer, it's probably electrical (or, an electric fuel pump!) ....


November 20th, 2019, 10:56 am
Profile
Firing on two.

Joined: June 22nd, 2014, 8:09 pm
Posts: 1180
Location: Reading, Berks UK
Post Re: Miss fire
Full throttle everywhere? You probably do that anyway though.


November 27th, 2019, 12:59 pm
Profile
Firing on two.
User avatar

Joined: January 1st, 2009, 7:37 pm
Posts: 4695
Location: Disunited Kingdom
Post Re: Miss fire
Well, my 123ignition gave up the ghost two weeks ago, after 16+years and close to 200k miles. I've bought a new one from ECAS and there's an additional piece of paper that states that the standard 123 will fail if a 'super coil' is used, so maybe it's a thing with Luminition too. I don't have a 'super coil' fitted.

_________________
1988 built (1989 F-registered) Citroën 2CV-Six
2013 (63-Plate) VW Golf SE 1.4TSI BMT DSG7
1932 Morris Minor Open Two-Seater (The £100 car).
Image
Image


November 27th, 2019, 3:41 pm
Profile
Firing on two.
User avatar

Joined: March 21st, 2013, 12:04 am
Posts: 1581
Location: Exeter, Devon
Post Re: Miss fire
I would be surprised if it was the lummy itself. Could be a connector of course. Or plugs even. Coil, HT leads. Then there fuel and air leaks. Tappets are sounding tappity. :D

I'll start looking properly. :)

_________________
If you can't fix it with a hammer, it's probably electrical (or, an electric fuel pump!) ....


November 27th, 2019, 6:22 pm
Profile
Agony Aunt - You have a car problem? Speak to Ken

Joined: March 6th, 2009, 1:40 am
Posts: 3675
Post Re: Miss fire
Roger,
not sure if I've already asked this, but has the carburettor been rejetted yet?

Any hesitation/ 'almost' misfiring due to a weak mixture on the primary choke will be much more pronounced in cold weather.

_________________
Image


November 27th, 2019, 7:52 pm
Profile
Firing on two.
User avatar

Joined: March 21st, 2013, 12:04 am
Posts: 1581
Location: Exeter, Devon
Post Re: Miss fire
Hi Ken

Yes you did back in late February. It has a dyane cowl and pipework. You suggested 110 primary jet.

Not convinced its fuel, but you never know. :)

_________________
If you can't fix it with a hammer, it's probably electrical (or, an electric fuel pump!) ....


November 28th, 2019, 12:04 am
Profile
Firing on two.
User avatar

Joined: October 22nd, 2014, 10:59 pm
Posts: 2005
Location: South-Limburg
Post Re: Miss fire
is the little injection pump on the carb working?


November 28th, 2019, 9:24 am
Profile
Firing on two.
User avatar

Joined: March 21st, 2013, 12:04 am
Posts: 1581
Location: Exeter, Devon
Post Re: Miss fire
That appears to work ok under normal driving conditions. This only happens if I open the throttle a little bit.

I only noticed it because i was trying a new ignition system and it was running badly. I swapped it back to compare and there it was.

_________________
If you can't fix it with a hammer, it's probably electrical (or, an electric fuel pump!) ....


November 28th, 2019, 10:14 am
Profile
Firing on two.
User avatar

Joined: March 21st, 2013, 12:04 am
Posts: 1581
Location: Exeter, Devon
Post Re: Miss fire
I think I may have resolved this, this morning, but we wIll see. :)

For the new ignition system I am currently fighting with, I have coil on plugs (VAG bosch 036 905 715).I used the same ground point on the bulkhead, as the regulator ground. When on the old system (lumenition), I noticed the max voltage had risen slightly when reving the engine. I decided to move the cop ground to the gearbox, and make good the regulator ground.

Result

The mis fire has gone, and I have a rock solid idle!

Still the new system to sort though. I've ordered some resistor type spark plugs. :D

_________________
If you can't fix it with a hammer, it's probably electrical (or, an electric fuel pump!) ....


December 8th, 2019, 1:29 pm
Profile
Firing on two.
User avatar

Joined: March 5th, 2009, 6:23 pm
Posts: 2140
Location: Near Monmouth
Post Re: Miss fire
Hi Roger,
Which ignition system.?
Need a cop driver design/circuit??
Have 2 cop units with connector plugs only 2 wire.
About < 1 ohm each, loath to try them in the 123 ignition as they state min off 1.5 ohms
Any hints

Cheers
Peter


December 8th, 2019, 3:03 pm
Profile
Display posts from previous:  Sort by  
Reply to topic   [ 22 posts ]  Go to page 1, 2, 3  Next

Who is online

Users browsing this forum: No registered users and 29 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group.
Designed by STSoftware for PTF.