| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| camshaft followers http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=6122 |
Page 1 of 1 |
| Author: | kitwhite [ May 7th, 2018, 7:36 pm ] |
| Post subject: | camshaft followers |
Hi I'm getting ny Camshaft reprofiled do I need to replace my camfollowers or not |
|
| Author: | Derek [ May 7th, 2018, 9:33 pm ] |
| Post subject: | Re: camshaft followers |
Depends on the condition of the face that contacts the cam. If pitted or otherwise ridged - yes. If not, probably no. |
|
| Author: | ken [ May 7th, 2018, 10:13 pm ] |
| Post subject: | Re: camshaft followers |
http://russellengineering.com.au/camshaft-followers/ |
|
| Author: | kitwhite [ May 8th, 2018, 11:59 pm ] |
| Post subject: | Re: camshaft followers |
still unsure what to do the follows dont look worn. should they be flat or domed? |
|
| Author: | ken [ May 9th, 2018, 12:32 am ] |
| Post subject: | Re: camshaft followers |
Kit, "very" slightly domed, with a radius of about 1.8 metres, or 73" if you're living in the past...  . p.s. Can anyone explain, in easy steps, how to get rid of this intrusive 'Phucked-up-bucket' garbage? As far as I can recall, I've never had any dealings with that crew. |
|
| Author: | Roger V [ May 9th, 2018, 12:45 am ] |
| Post subject: | Re: camshaft followers |
Try this Ken viewtopic.php?f=4&t=6079 |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|