International2cvFriends.com
http://www.international2cvfriends.com/forum/

Welding thin plate
http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=6025		 Page 1 of 1
Author:  AZL57 [ July 20th, 2017, 8:59 pm ]
Post subject:  Welding thin plate
I welded today on a Russian Moskvich. It's metal was even thinner than that of a 2cv... The lower chassisbar and sill were rotten through caused by a leaking 4,5 volt battery..... :geek: :mrgreen:
https://i11.servimg.com/u/f11/18/22/17/20/dscn1110.jpg
Author:  AZL57 [ July 20th, 2017, 9:00 pm ]
Post subject:  Re: Welding thin plate
This forum program does refuse my pictures very often....
Author:  ken [ July 21st, 2017, 1:41 am ]
Post subject:  Re: Welding thin plate
At least one reader has fallen for it... :)
Author:  AZL57 [ July 21st, 2017, 6:38 pm ]
Post subject:  Re: Welding thin plate
it's not the stupid photobucket but the forum that said cannot determine the picture size??? I have had this more than once here? ;-)
Author:  subarupete [ July 21st, 2017, 8:03 pm ]
Post subject:  Re: Welding thin plate
This forum limits images to 1mb. On windows right click to get info?
Author:  AZL57 [ July 21st, 2017, 9:57 pm ]
Post subject:  Re: Welding thin plate
pic is 228 kb so that shouldn't be a problem
Author:  subarupete [ July 22nd, 2017, 9:05 am ]
Post subject:  Re: Welding thin plate
My 2 bytes,

It should give an error message, (in Red) if the image is to large.

Until recently, I found I had to make a few attempts to upload a picture.
For my connection a basic (3Mb) at busy times the upload failed.
I guess the host site, times-out, waiting to a response from a slow upload.
Author:  AZL57 [ July 22nd, 2017, 3:31 pm ]
Post subject:  Re: Welding thin plate
Ah well, stupid computers ;-)
Page 1 of 1 All times are UTC + 1 hour [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/