| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| Van seat belts http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=6022 |
Page 1 of 4 |
| Author: | bobh [ June 23rd, 2017, 8:45 pm ] |
| Post subject: | Van seat belts |
I have a re-chassied 1962 AZU van. The seatbelt mounting holes are in the new floor and on the new side rails, but there are no brackets for mountings behind the seat/ side shelves. Does anyone make these brackets / have drawings for them? BobH |
|
| Author: | AZL57 [ June 23rd, 2017, 10:50 pm ] |
| Post subject: | Re: Van seat belts |
They are pyramid shaped brackets welded on the top of the innerwings. They were in the aks400 and the ak250 from the ,70s. |
|
| Author: | AZL57 [ June 23rd, 2017, 10:52 pm ] |
| Post subject: | Re: Van seat belts |
strange i type ak 400 and it shows up as aks400??? |
|
| Author: | Dennis [ June 25th, 2017, 2:17 pm ] |
| Post subject: | Re: Van seat belts |
Bob - shall I send you a picture of mine? They look highly authentic..... |
|
| Author: | bobh [ June 25th, 2017, 8:15 pm ] |
| Post subject: | Re: Van seat belts |
Thanks Den |
|
| Author: | Dennis [ June 26th, 2017, 6:24 pm ] |
| Post subject: | Re: Van seat belts |
  These show the after-market seat belt mounts on my AZU, probably manufactured for, and installed by, the French Post office who were the original owner. They aren't welded on, as you can see. Try to ignore the dust, dents, rust etc. It's living in a very dusty barn at the moment. But One Day I'll clean it all up..... |
|
| Author: | bobh [ June 26th, 2017, 6:35 pm ] |
| Post subject: | Re: Van seat belts |
What re the "letter box slots" in the bulkhead behind the seats. Are they just deep enough for the vehicle docs etc. |
|
| Author: | Dennis [ June 26th, 2017, 6:43 pm ] |
| Post subject: | Re: Van seat belts |
They wouldn't hold much more than a single sheet of paper. The opening is about 15cm wide by 6cm high (it's dark in the barn and difficult to measure), so perhaps for a carte grise. But the orientation is wrong: a (modern) CG is portrait format and this is landscape. There's only one, at the top of the bulkhead behind the driver's seat. |
|
| Author: | Geert [ June 26th, 2017, 7:21 pm ] |
| Post subject: | Re: Van seat belts |
bobh wrote: What re the "letter box slots" in the bulkhead behind the seats. Are they just deep enough for the vehicle docs etc. Never seen these before. Interesting ! |
|
| Author: | Dennis [ June 26th, 2017, 8:07 pm ] |
| Post subject: | Re: Van seat belts |
Fiat Lux ... et lux erat:  The two screws keep the papers in. I imagine there was a transparent plastic pane at the front. |
|
| Page 1 of 4 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|