I usually go to ecas for bits
http://www.ecas2cvparts.co.uk/-c-13.html
Don't be put off by the P&P looking a bit high as there is usually a refund a few days later.
This doesn't mean parts aren't available elsewhere.
| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| Recommendation for carb overhaul kit. http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=5992 |
Page 1 of 2 |
| Author: | Devils Advocate [ May 4th, 2017, 7:37 pm ] |
| Post subject: | Recommendation for carb overhaul kit. |
Hi all. This is a very low mileage Solex 26/35, so no actual metal wear, so no jets etc required. But it is old so diaphragms etc. will likely be perished. Where do folks go for a gasket/rubber-bits only kit? Thanks. |
|
| Author: | Roger V [ May 4th, 2017, 8:00 pm ] |
| Post subject: | Re: Recommendation for carb overhaul kit. |
I usually go to ecas for bits http://www.ecas2cvparts.co.uk/-c-13.html Don't be put off by the P&P looking a bit high as there is usually a refund a few days later. This doesn't mean parts aren't available elsewhere.
|
|
| Author: | Devils Advocate [ May 5th, 2017, 12:53 pm ] |
| Post subject: | Re: Recommendation for carb overhaul kit. |
Thanks Roger - I'll have a good look through. |
|
| Author: | Sean [ May 6th, 2017, 8:45 am ] |
| Post subject: | Re: Recommendation for carb overhaul kit. |
Devils Advocate wrote: Hi all. Where do folks go for a gasket/rubber-bits only kit? Thanks. rubber bits? theres an o ring on the acc jet and thats it |
|
| Author: | Derek [ May 6th, 2017, 9:31 am ] |
| Post subject: | Re: Recommendation for carb overhaul kit. |
Unless he means the accelerator pump diaphragm? |
|
| Author: | Roger V [ May 6th, 2017, 10:35 am ] |
| Post subject: | Re: Recommendation for carb overhaul kit. |
What's the acc jet 
|
|
| Author: | Devils Advocate [ May 7th, 2017, 1:03 pm ] |
| Post subject: | Re: Recommendation for carb overhaul kit. |
Tee-hee! Yes, I mean the accel diaphragm (and the choke pull-off one too?) The carb is typically 2CV old, but less than 10k miles. So I'm assuming no actual wear but plenty perished bits... |
|
| Author: | Sean [ May 7th, 2017, 9:36 pm ] |
| Post subject: | Re: Recommendation for carb overhaul kit. |
accelerator jet Diaphragms arent rubber |
|
| Author: | Devils Advocate [ May 15th, 2017, 12:17 am ] |
| Post subject: | Re: Recommendation for carb overhaul kit. |
Rubbery, then... |
|
| Author: | Derek [ May 15th, 2017, 1:36 pm ] |
| Post subject: | Re: Recommendation for carb overhaul kit. |
As has been mentioned: http://www.ecas2cvparts.co.uk/-c-13_15. ... =1&sort=3a A few rubbery bits in there. I'm guessing you have what you need now? |
|
| Page 1 of 2 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|