Recommendation for carb overhaul kit.
| Author |
Message |
|
Devils Advocate
Firing on two.
Joined: July 26th, 2009, 3:36 pm
Posts: 1019
|
 Recommendation for carb overhaul kit. Hi all.
This is a very low mileage Solex 26/35, so no actual metal wear, so no jets etc required. But it is old so diaphragms etc. will likely be perished.
Where do folks go for a gasket/rubber-bits only kit?
Thanks.
|
| May 4th, 2017, 7:37 pm |
|
|
|
Roger V
Firing on two.
Joined: March 21st, 2013, 12:04 am
Posts: 1581
Location: Exeter, Devon
|
Re: Recommendation for carb overhaul kit. I usually go to ecas for bits http://www.ecas2cvparts.co.uk/-c-13.htmlDon't be put off by the P&P looking a bit high as there is usually a refund a few days later. This doesn't mean parts aren't available elsewhere. 
_________________
If you can't fix it with a hammer, it's probably electrical (or, an electric fuel pump!) ....
|
| May 4th, 2017, 8:00 pm |
|
|
|
Devils Advocate
Firing on two.
Joined: July 26th, 2009, 3:36 pm
Posts: 1019
|
Re: Recommendation for carb overhaul kit. Thanks Roger - I'll have a good look through.
|
| May 5th, 2017, 12:53 pm |
|
|
|
Sean
Firing on two.
Joined: April 22nd, 2009, 11:06 pm
Posts: 3684
Location: Ecosse
|
Re: Recommendation for carb overhaul kit. Devils Advocate wrote: Hi all.
Where do folks go for a gasket/rubber-bits only kit?
Thanks. rubber bits? theres an o ring on the acc jet and thats it
_________________
Kissing the Lash
"Any advice of a technical nature is given on the understanding that I've actually done this shit, not just read about it in D*lly club mag some time ago.
|
| May 6th, 2017, 8:45 am |
|
|
|
Derek
Firing on two.
Joined: April 20th, 2017, 10:55 pm
Posts: 107
|
Re: Recommendation for carb overhaul kit. Unless he means the accelerator pump diaphragm?
|
| May 6th, 2017, 9:31 am |
|
|
|
Roger V
Firing on two.
Joined: March 21st, 2013, 12:04 am
Posts: 1581
Location: Exeter, Devon
|
Re: Recommendation for carb overhaul kit. What's the acc jet 
_________________
If you can't fix it with a hammer, it's probably electrical (or, an electric fuel pump!) ....
|
| May 6th, 2017, 10:35 am |
|
|
|
Devils Advocate
Firing on two.
Joined: July 26th, 2009, 3:36 pm
Posts: 1019
|
Re: Recommendation for carb overhaul kit. Tee-hee!
Yes, I mean the accel diaphragm (and the choke pull-off one too?)
The carb is typically 2CV old, but less than 10k miles. So I'm assuming no actual wear but plenty perished bits...
|
| May 7th, 2017, 1:03 pm |
|
|
|
Sean
Firing on two.
Joined: April 22nd, 2009, 11:06 pm
Posts: 3684
Location: Ecosse
|
Re: Recommendation for carb overhaul kit. accelerator jet
Diaphragms arent rubber
_________________
Kissing the Lash
"Any advice of a technical nature is given on the understanding that I've actually done this shit, not just read about it in D*lly club mag some time ago.
|
| May 7th, 2017, 9:36 pm |
|
|
|
Devils Advocate
Firing on two.
Joined: July 26th, 2009, 3:36 pm
Posts: 1019
|
Re: Recommendation for carb overhaul kit. Rubbery, then...
|
| May 15th, 2017, 12:17 am |
|
|
|
Derek
Firing on two.
Joined: April 20th, 2017, 10:55 pm
Posts: 107
|
Re: Recommendation for carb overhaul kit. As has been mentioned: http://www.ecas2cvparts.co.uk/-c-13_15. ... =1&sort=3aA few rubbery bits in there. I'm guessing you have what you need now?
|
| May 15th, 2017, 1:36 pm |
|
|
Who is online |
Users browsing this forum: No registered users and 104 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
