| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| Van tie rods http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=5952 |
Page 1 of 1 |
| Author: | Boggy [ February 4th, 2017, 2:23 pm ] |
| Post subject: | Van tie rods |
Hi all Are AK 400 front tie rods same length as saloon front tie rods? cheers Boggy |
|
| Author: | ken [ February 4th, 2017, 10:29 pm ] |
| Post subject: | Re: Van tie rods |
Depends on the age of the van. Pre- 05/68, they were 225mm, after that 192mm. 2CV, Dyane, etc. listed as 193mm Boggy wrote: Hi all Are AK 400 front tie rods same length as saloon front tie rods? cheers Boggy  Springs 1 by slcchassis, on Flickr
|
|
| Author: | Boggy [ February 4th, 2017, 11:30 pm ] |
| Post subject: | Re: Van tie rods |
Cheers Ken So 642mm front and 600mm rear on a '72 Boggy |
|
| Author: | ken [ February 5th, 2017, 2:28 pm ] |
| Post subject: | Re: Van tie rods |
Apologies, Bob, made a complete nonsense of that, quoting spring lengths instead of tie rod lengths. 642mm is what you need, which is the same as some rear tie rods used on other (earlier) A series. By coincidence, I'd been sorting out the paperwork for an AKS400 chassis which is being loaded today to go to South Africa. Guess I ought to concentrate on the job in hand...  Boggy wrote: Cheers Ken So 642mm front and 600mm rear on a '72 Boggy |
|
| Author: | Boggy [ February 5th, 2017, 3:23 pm ] |
| Post subject: | Re: Van tie rods |
No problem Ken the chart did help though !! Never had suspension this rusty everything solid Bob |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|