| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| Lumenition http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=590 |
Page 1 of 1 |
| Author: | Daffy Duck [ July 17th, 2009, 3:46 am ] |
| Post subject: | Lumenition |
I have Lumenition on one of my 2CVs, and 123 EVO on the other one. I intend to swap the 123 EVO from my Raid 2CV to my Town 2CV and move the Lumenition from the Town car to the Raid car. The main reason for doing this is that Lumenition is less susceptible to water damage with the electronics up on the firewall. Also the 123 EVO is "tunable" and more suited to increasing performance on the Town car which is guaranteed a diet of 98 octane fuel. The problem I have is that the Lumenition came with the car, so I have no diagram or fitting/timing instructions. Does anyone out there have those instructions and could they scan them and post them on this site? Daffy Duck |
|
| Author: | ken [ July 17th, 2009, 11:16 am ] |
| Post subject: | Re: Lumenition |
Daffy, I've found this, which should be a start for you... < http://www.bccp.nl/techdocs/PMA50ins.pdf > As regards setting the ignition timing, my recommendation would be the same as for points, to treat the static setup procedure as solely a starting point and to optimise the timing for your engine using a strobe. Ken ( More later perhaps, but got to go and clear up after this morning's storm, which was so intense that the thunder sounded like a 21 gun salute.  )
|
|
| Author: | Daffy Duck [ July 17th, 2009, 12:24 pm ] |
| Post subject: | Re: Lumenition |
Ken, Thank you. Daffy duck |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|