| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| LHM seals http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=5818 |
Page 1 of 1 |
| Author: | subarupete [ June 7th, 2016, 11:51 am ] |
| Post subject: | LHM seals |
What is the type of rubber used in LHM seals??? |
|
| Author: | jasu [ June 7th, 2016, 12:05 pm ] |
| Post subject: | Re: LHM seals |
Nitrile, NBR. Also Viton works well but it is harder than NBR... With DOT4 etc, the material is EPDM... |
|
| Author: | subarupete [ June 7th, 2016, 12:47 pm ] |
| Post subject: | Re: LHM seals |
Thanks. Been looking at solenoid valves (12volt) for a "Line lock", have found some with NBR seals:) |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|