International2cvFriends.com
http://www.international2cvfriends.com/forum/

Pushrod Tube Replacement
http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=5811
Page 1 of 1

Author:  adam_d [ May 16th, 2016, 7:28 pm ]
Post subject:  Pushrod Tube Replacement

How bad a job is this to someone that's never done it before? I see the ECAS site says it's a difficult job, and I've seen a Rawlbolt mentioned as a way of expanding the new tubes.

I've just learned the hard way not to try and replace the head the quick way after sealing a hole in one of my tubes. :( I was hoping to do a bit of reassembly each night as I needed the car at the weekend.

Thanks guys.

Page 1 of 1 All times are UTC + 1 hour [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/