So I've finally taken the windscreen panel out of my 1982 car and committed to restoring it (I've taken lots of photos and will add them to its thread soon here's but a cheeky one
)
To save on shipping - as I understand there's a surcharge on panels such as windscreen panel - I want to order all the big stuff at once. All the other panels without question on the list need ordering but I to run this one past you.
http://www.ecas2cvparts.co.uk/lower-bulkhead-board-right-hand-drive-zinc-plated-complete-section-assembled-super-quality-p-2219.html
The lower most part of the bulkhead is definitely the worst part it is barely attached the passenger floor pan if at all and will push really easily where I'm pointing.
Moving over to the driver's side, that's better however there's an obvious patch but its solid but if I'm doing the car up, I'd like to improve on that a little bit if I can.
Moving to the other side there's corrosion on the N/S here.
As well as were it meets the upper bulkhead here.
No doubt there's more but until I take the tub off and have a good poke about and take a grinder to it that's all I can show. So what do we think?
still at least the parts are relatively plentiful and the lower bulkhead is apparently well made.