'Same as it ever was'...
https://www.youtube.com/watch?v=I1wg1DNHbNU
Russell wrote:
M11x1mm
| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| Tie rod thread size http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=5649 |
Page 1 of 1 |
| Author: | French Tickler [ May 23rd, 2015, 9:05 pm ] |
| Post subject: | Tie rod thread size |
Hi, the thread at the end of the tie rod which screws into the suspension tie rod end eye, has been damaged. I need to cut a new thread to start the thread run off again. To that end, what size is the thread, all my taps & dies sets don't seem to fit. Thanks. |
|
| Author: | AZL57 [ May 23rd, 2015, 9:54 pm ] |
| Post subject: | Re: Tie rod thread size |
11x100 says the 12/18 HP parts catalogue... anyone can confirm if this is also the size for the modern versions? |
|
| Author: | Russell [ May 23rd, 2015, 10:02 pm ] |
| Post subject: | Re: Tie rod thread size |
M11x1mm |
|
| Author: | ken [ May 24th, 2015, 1:28 am ] |
| Post subject: | Re: Tie rod thread size |
'Same as it ever was'... https://www.youtube.com/watch?v=I1wg1DNHbNU Russell wrote: M11x1mm |
|
| Author: | French Tickler [ May 24th, 2015, 11:38 am ] |
| Post subject: | Re: Tie rod thread size |
ken wrote: Ouch Ken, Skewered by your rapier like whit. :
|
|
| Author: | French Tickler [ May 24th, 2015, 11:52 am ] |
| Post subject: | Re: Tie rod thread size |
Russell wrote: M11x1mm Thank you Russell 
|
|
| Author: | French Tickler [ May 24th, 2015, 11:52 am ] |
| Post subject: | Re: Tie rod thread size |
AZL57 wrote: 11x100 says the 12/18 HP parts catalogue... anyone can confirm if this is also the size for the modern versions? thank you AZL57 
|
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|