"Tread" = "thread", perhaps?
Don't forget that one side of the track adjusting sleeve setup is left hand threaded, can't remember which way round it is, but fairly sure that it's the track rod end housing end...
| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| What size is the tread on Track Rod end housIng ?? http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=5538 |
Page 1 of 1 |
| Author: | oboe [ February 8th, 2015, 8:49 pm ] |
| Post subject: | What size is the tread on Track Rod end housIng ?? |
what size is the tread on a track rod head housing ??? Cheers |
|
| Author: | chevrons2 [ February 8th, 2015, 9:27 pm ] |
| Post subject: | Re: What size is the tread on Track Rod end housIng ?? |
Do you mean the open end where the castlated nut goes? If so that's M24x1.5. If you mean the other end, where the tracking adjuster sleeve treads on, that's M14x1.25 (except on Ami Supers, which are M16x1.25). |
|
| Author: | oboe [ February 8th, 2015, 9:51 pm ] |
| Post subject: | Re: What size is the tread on Track Rod end housIng ?? |
Cheers |
|
| Author: | ken [ February 9th, 2015, 1:10 am ] |
| Post subject: | Re: What size is the tread on Track Rod end housIng ?? |
"Tread" = "thread", perhaps? Don't forget that one side of the track adjusting sleeve setup is left hand threaded, can't remember which way round it is, but fairly sure that it's the track rod end housing end... |
|
| Author: | 2CViking [ February 9th, 2015, 9:54 am ] |
| Post subject: | Re: What size is the tread on Track Rod end housIng ?? |
Both sides are the same, no left of right parts. |
|
| Author: | ken [ February 9th, 2015, 12:27 pm ] |
| Post subject: | Re: What size is the tread on Track Rod end housIng ?? |
2CViking wrote: Both sides are the same, no left of right parts. Offside/right hand side housing...  Nearside/left hand side housing... 
|
|
| Author: | 2CViking [ February 9th, 2015, 1:38 pm ] |
| Post subject: | Re: What size is the tread on Track Rod end housIng ?? |
Only related to the split pin not the thread. Left and Right have the same thread (left hand) Both track rods and connecting sleeves are standard threads. |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|