International2cvFriends.com
http://www.international2cvfriends.com/forum/

Hubs/drive flanges
http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=5459
Page 1 of 1

Author:  Russell [ November 21st, 2014, 11:26 pm ]
Post subject:  Hubs/drive flanges

Can you just press the drive flanges out of the hub carrier with a vice/fly press/bench press?

Author:  Pony [ November 21st, 2014, 11:31 pm ]
Post subject:  Re: Hubs/drive flanges

pull the hub out with 2 tyre levers
probably the outer bearing race will stay on the flange
pony

Author:  Russell [ November 21st, 2014, 11:42 pm ]
Post subject:  Re: Hubs/drive flanges

Thanks Louis.

Author:  Pony [ November 22nd, 2014, 12:02 am ]
Post subject:  Re: Hubs/drive flanges

no worries
do you still hate glass???
do you go to Poland

Author:  Russell [ November 22nd, 2014, 12:09 am ]
Post subject:  Re: Hubs/drive flanges

It's a fucking stupid material, that's for sure. Polands off for me I reckon, I won't have the car done by then.

Author:  Pony [ November 22nd, 2014, 9:56 pm ]
Post subject:  Re: Hubs/drive flanges

that is 8 months WTF you doing??

i can build 30 chassis in that time and still go down the pub!!

Author:  Russell [ November 22nd, 2014, 9:57 pm ]
Post subject:  Re: Hubs/drive flanges

If you fancy financing it, I could get it done in a couple of weeks.

Author:  citroenboat [ November 22nd, 2014, 10:40 pm ]
Post subject:  Re: Hubs/drive flanges

Quote:
i can build 30 chassis in that time and still go down the pub!!

Well Russ, what were we saying earlier? Nice shiny new panels and a spot welder we'd be happy? Rather than poking around nasty rusty old crap.... In fact given that, I could probably knock out new shells in enough quantity that I could afford one of Louis rolling chassis to go under the AZU - then I'd be a happy boy! :D :D :D

Author:  Neil [ November 22nd, 2014, 11:00 pm ]
Post subject:  Re: Hubs/drive flanges

Russell wrote:
If you fancy financing it, I could get it done in a couple of weeks.


:lol:

Page 1 of 1 All times are UTC + 1 hour [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/