| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| Cylinder head temp sensors http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=5441 |
Page 1 of 1 |
| Author: | Diesel Dave [ October 31st, 2014, 2:00 pm ] |
| Post subject: | Cylinder head temp sensors |
Question for the tuners and possibly racers out there. I have some old Plug Ring type cylinder head temp gauges That I'd like to fit, just so I can see what's going on for interest more than anything else. As the plugs are inset a little the ring sensors won't fit unless I Dremel out a little space for the 'sticky out bit'. I trust it's safe enough to do this, and I won't cause a crack stress riser as a result... 
|
|
| Author: | subarupete [ October 31st, 2014, 2:09 pm ] |
| Post subject: | Re: Cylinder head temp sensors |
photo please |
|
| Author: | Diesel Dave [ October 31st, 2014, 2:51 pm ] |
| Post subject: | Re: Cylinder head temp sensors |
Ok so cylinder head and spark plug recess  Ring sensor  So I would need to relieve just a little section to allow for the 'sticky out bit', it won't bend sufficiently to clear. |
|
| Author: | subarupete [ October 31st, 2014, 3:46 pm ] |
| Post subject: | Re: Cylinder head temp sensors |
You can trim the plastic to give clearance for the Spark Plug. The plastic gives some strain-relief to the cable. Make sure the hole fits the plug as a loose fit. Mine got jammed on the threads of the plug and the cable got pulled out. The plastic doesn't do much anyway, as the TC is "crimped in". Attachment: tc2.jpg Got mine here, bit of a wait http://www.ebay.co.uk/itm/Thermocouple- ... 3a70c319c4 |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|