| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| Extra gease nipple on top kingpin bush http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=5366 |
Page 1 of 1 |
| Author: | Vosper2004 [ August 17th, 2014, 10:01 am ] |
| Post subject: | Extra gease nipple on top kingpin bush |
Hi, I read somewhere some time ago about this mod so as I had to replace a king pin set I thought I'd try it. Drilling and tapping the casting for the grease nipple was no problem but I could not get a drill to touch the bearing. Anyone know of this mod or has tried it? Don |
|
| Author: | ayjay [ August 18th, 2014, 12:31 am ] |
| Post subject: | Re: Extra gease nipple on top kingpin bush |
hi vosper can you elaborate a picture maybye? |
|
| Author: | Vosper2004 [ August 18th, 2014, 12:32 pm ] |
| Post subject: | Re: Extra gease nipple on top kingpin bush |
Hi, Sorry, no picture. Just came across this some time ago whilst looking for 2CV info and can't remember where I first saw it. I assume this was to overcome the problem of grease not always getting to the top bush. I have regularly greased both sides equally but the the right hand side seems to have worn whereas the left hasn't. As the posting hasn't generated much response perhaps I dreamt it  Don |
|
| Author: | Taskos [ August 18th, 2014, 2:42 pm ] |
| Post subject: | Re: Extra gease nipple on top kingpin bush |
King Pin Mod. |
|
| Author: | Taskos [ August 18th, 2014, 2:59 pm ] |
| Post subject: | Re: Extra gease nipple on top kingpin bush |
http://www.pp-2cv.be/FR/News/KitPivot.htm |
|
| Author: | AZS [ August 18th, 2014, 4:05 pm ] |
| Post subject: | Re: Extra gease nipple on top kingpin bush |
This solution should work quite good and should't be to difficult to fabricate. |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|