Hi,
Roughly how long in a 2cv6 gearbox? from front face of bell housing to most rearward point and also if possible the width between the drive shaft flanges.
| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| 2cv gearbox length http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=4972 |
Page 1 of 1 |
| Author: | db78 [ September 4th, 2013, 8:16 pm ] |
| Post subject: | 2cv gearbox length |
Hi, Roughly how long in a 2cv6 gearbox? from front face of bell housing to most rearward point and also if possible the width between the drive shaft flanges.
|
|
| Author: | toomany2cvs [ September 4th, 2013, 8:54 pm ] |
| Post subject: | Re: 2cv gearbox length |
db78 wrote: Hi, Roughly how long in a 2cv6 gearbox? from front face of bell housing to most rearward point and also if possible the width between the drive shaft flanges. <rummages in back of ill-lit shed> From front of bellhousing to gearbox mount, about 450mm. If you include the input shaft, more like 480. Width - about 350. |
|
| Author: | Sean [ September 4th, 2013, 9:46 pm ] |
| Post subject: | Re: 2cv gearbox length |
ive got a shorter one if you need it, only ran 23'35" since a re build, bell housing is a bit of a mess.  bit of an issue |
|
| Author: | Russell [ September 4th, 2013, 10:21 pm ] |
| Post subject: | Re: 2cv gearbox length |
I wish I'd seen it go. Must've been like a grenade going off. Did you get all of the flywheel back? Could you weld it back together? No issues. |
|
| Author: | Sean [ September 5th, 2013, 7:58 am ] |
| Post subject: | Re: 2cv gearbox length |
cast so welding difficult "JB weld" is better! "As strong as a weld" and i can "machine and tap it just like metal" in fact im just going to buy 100 tubes and make a JB flywheel |
|
| Author: | J-dub [ September 5th, 2013, 8:16 am ] |
| Post subject: | Re: 2cv gearbox length |
Looks like a broken egg |
|
| Author: | db78 [ September 5th, 2013, 7:14 pm ] |
| Post subject: | Re: 2cv gearbox length |
toomany2cvs wrote: db78 wrote: Hi, Roughly how long in a 2cv6 gearbox? from front face of bell housing to most rearward point and also if possible the width between the drive shaft flanges. <rummages in back of ill-lit shed> From front of bellhousing to gearbox mount, about 450mm. If you include the input shaft, more like 480. Width - about 350. thank you Sean wrote: ive got a shorter one if you need it, only ran 23'35" since a re build, bell housing is a bit of a mess. impressive! but aslo gutted for you running so close to the finish.. |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|