HMM! No wonder I ache a bit this morning!
I managed to get it into the back of the van, using a piece of board and a series of 'steps' I built from old wheels. Getting it back out was slightly easier and a lot quicker than I'd anticipated! 
| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| weight of engine http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=4928 |
Page 1 of 1 |
| Author: | Mark350 [ July 30th, 2013, 12:21 am ] |
| Post subject: | weight of engine |
How much would a complete Dyane engine weigh, with a gearbox, the driveshafts and the exhaust crossbox still attached? |
|
| Author: | toomany2cvs [ July 30th, 2013, 9:32 am ] |
| Post subject: | Re: weight of engine |
Mark350 wrote: How much would a complete Dyane engine weigh, with a gearbox, the driveshafts and the exhaust crossbox still attached? Two-person carryable with reasonable ease. Not one-person. An engine without box is borderline for one person if it's got the heavy flywheel still attached. One person can _just_ manhandle a complete engine/box setup into the chassis, but it's a bit "heave-lever-rest-wiggle". TBH, I'd just split the engine and box. |
|
| Author: | Mark350 [ July 30th, 2013, 10:56 am ] |
| Post subject: | Re: weight of engine |
HMM! No wonder I ache a bit this morning! I managed to get it into the back of the van, using a piece of board and a series of 'steps' I built from old wheels. Getting it back out was slightly easier and a lot quicker than I'd anticipated!
|
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|