International2cvFriends.com
http://www.international2cvfriends.com/forum/

Acad rear brake drum nut
http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=4880		 Page 1 of 1
Author:  smyth602 [ June 29th, 2013, 11:43 pm ]
Post subject:  Acad rear brake drum nut
This may be a stupid question, but is the nut which holds the acad rear drum on larger than on a 2cv? I assumed that as the bearings etc are larger the drum nut would be too, but I can't find anyone selling anything other than the 44mm drum nut...

Hope someone can help!
Author:  lpgo [ June 30th, 2013, 12:41 am ]
Post subject:  Re: Acad rear brake drum nut
Nut is the same, only outer diameter of bearing is diffrent
Author:  smyth602 [ June 30th, 2013, 12:48 am ]
Post subject:  Re: Acad rear brake drum nut
I feel very, very stupid now... :/
Author:  lpgo [ June 30th, 2013, 9:59 am ]
Post subject:  Re: Acad rear brake drum nut
That's the forum for......



To feel stupid..........




I have it all the time.... ;) ;) ;) ;)
Author:  ken [ June 30th, 2013, 11:20 pm ]
Post subject:  Re: Acad rear brake drum nut
lpgo,
I'm fairly sure that the inner bore of an Ami/AK/Acad wheel bearing is also larger than that of a 'standard' A series, even though the nut is the same... :?
ken




lpgo wrote:
Nut is the same, only outer diameter of bearing is diffrent
Author:  lpgo [ July 1st, 2013, 12:35 am ]
Post subject:  Re: Acad rear brake drum nut
You see :lol: :lol: :lol: :lol: :lol:
Author:  callumbeveridge [ July 4th, 2013, 4:50 pm ]
Post subject:  Re: Acad rear brake drum nut
I have a rear brake adjusting tool which is too big to fit into the bearing on a standard 2cv rear drum. Therefore, I assumed that the inner diameter of the bearing on a van is bigger than the car.

Is this not the case?

Rgrds
Callum
Page 1 of 1 All times are UTC + 1 hour [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/