| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| King Pin Swap http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=48 |
Page 1 of 1 |
| Author: | Tim2cv [ January 6th, 2009, 3:29 pm ] |
| Post subject: | King Pin Swap |
Standard arms, lowered suspension or just lazy? You may need this eventually if you dont grease regularly! Its not a hard job with the propper drift set, a very large vice and a big hammer! For those of you who have lost, damaged etc the easy how to instructions that came with the propper (Ecas) drift set then I have attached that as I laminated mine after it nearly went bye byes! Other tricks such as increasing the dome of the top cap using a large ball bearing and socket etc make fitting much easier! |
|
| Author: | Rumble602 [ January 29th, 2009, 1:00 am ] |
| Post subject: | Re: King Pin Swap |
I've got a homemade press to push out old pins and fit new ones. Years old now, but works fine. Much less brutal than drifting out pins. Available to any mates if needed. |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|