I fitted my uprated suspension cans to the car and the tie rods seem to long ant the front and too short at the rear...
The uprated springs are the same physical dimensions/length as the originals but 1mm thicker material.
There was only 15mm+/- difference between the length of the tie rod protruding out of the can front and rear, I put the longest towards the back and have the AV markings at the front.
At the rear I have 310mm ground clearance and 65mm of thread left, 10mm in rod end.
At the front I have 240mm Ground clearance and 10mm thread left, close to bottoming out in rod end.
Thinking about it I should have the longest tie rod with the shortest spring at the rear and the shortest tie rod with the longest spring at the front...
Have I got it tits up!?
Tired Harley