International2cvFriends.com
http://www.international2cvfriends.com/forum/

carb/jet size query
http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=4065
Page 1 of 1

Author:  ayjay [ July 5th, 2012, 1:01 am ]
Post subject:  carb/jet size query

hi fella,s-only meeee :? my 2cv (602 cc)D*lly, twin choke carb, normal engine ,electronic iggy , high output coil-

well, when i,m driving/pottering along ,using a very light foot on the throttle- the first carb barrel only used-- the engine is very hesitant, it "hunts", kind of pulls then not in rapid succession :? it seems like the fuel delivery is not even-

if i floor it and the second butterfly opens all good :D goes like a rocket( comparetivly :lol: }
ive been told that if i remove the brass secondary? primary? petrol jet in the carb,- then drill it out slightly bigger- that will cure the problem :roll:
my question is ,can i just purchase a modified one

btw ive stripped the carb and cleaned it thorough-ly


a modified jet, a modified jet-- my kingdom for a modified jet :D

Author:  ken [ July 5th, 2012, 1:21 am ]
Post subject:  Re: card/jet size query

No kingdom or king's ransom required... :roll:

http://www.ecas2cvparts.co.uk/primary-v ... -1454.html

ken

Author:  ayjay [ July 5th, 2012, 2:35 am ]
Post subject:  Re: carb/jet size query

thanks so much ken :D top man --- smooooth runnnning -- i,ll get the correct one
cheers& thanks

Page 1 of 1 All times are UTC + 1 hour [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/