Is it possible (within the realms of cost-effectiveness) to repair this damage:
the bits do seem to be there still, they're just attached to a different part of the housing!
| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| air filter damage http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=4041 |
Page 1 of 1 |
| Author: | Mark350 [ June 20th, 2012, 1:10 pm ] |
| Post subject: | air filter damage |
Is it possible (within the realms of cost-effectiveness) to repair this damage: the bits do seem to be there still, they're just attached to a different part of the housing!
|
|
| Author: | ken [ June 20th, 2012, 3:41 pm ] |
| Post subject: | Re: air filter damage |
Mark, I've never seen one go like that before, maybe someone tried to get the lid off without undoing the butterfly nut?  Anyway, that looks as though it's a Dyane version, not a 2CV one, so are you going to Registers' Day? I've got about 4 Dyane metal air filter boxes spare... ken |
|
| Author: | 48pop [ June 20th, 2012, 4:49 pm ] |
| Post subject: | Re: air filter damage |
Looks like someone has been there before with the welder.......Maybe have another go if its a rare one.....Otherwise, sling it over a hedge and replace 
|
|
| Author: | Mark350 [ June 21st, 2012, 2:52 am ] |
| Post subject: | Re: air filter damage |
I believe it is a Dyane fitment - I acquired it (and a few other goodies) after being approached by an elderly gent in a pub car park while on my way to the Mallory Park races recently  It seems a shame to throw it away... I am almost certain to be at Registers Day, Ken - I hope to catch up with you there
|
|
| Author: | ken [ June 21st, 2012, 2:24 pm ] |
| Post subject: | Re: air filter damage |
Mark, in that case, it's too far gone to bother trying to repair it. Maybe hang onto the plastic filter insert and the butterfly nut, though? ken |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|