Been lent this
Attachment:
DSC00280.jpg
So I can now make turned parts, like drive shaft extensions, when i have solution, for running a 3phase lathe from a 13 amp plug
| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| Lets Torque http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=3929 |
Page 1 of 1 |
| Author: | dave 411 [ May 10th, 2012, 9:12 am ] |
| Post subject: | Lets Torque |
I am looking for the torque settings for the bolts that hold the front axle to the chassis. Anyone know? Thanks in advance. |
|
| Author: | subarupete [ May 10th, 2012, 9:27 am ] |
| Post subject: | Re: Lets Torque |
From Citroen Manual 5 da Nm or 36.10 ft lb Attachment: dave.jpg |
|
| Author: | dave 411 [ May 10th, 2012, 9:43 am ] |
| Post subject: | Re: Lets Torque |
Nice one Pete,hows the 4x4 coming on? |
|
| Author: | subarupete [ May 10th, 2012, 11:44 am ] |
| Post subject: | Re: Lets Torque |
Been lent this Attachment: DSC00280.jpg So I can now make turned parts, like drive shaft extensions, when i have solution, for running a 3phase lathe from a 13 amp plug
|
|
| Author: | Devils Advocate [ May 10th, 2012, 3:24 pm ] |
| Post subject: | Re: Lets Torque |
I think you'll need to replace the motor for a single-phase jobbie... 
|
|
| Author: | subarupete [ May 10th, 2012, 4:20 pm ] |
| Post subject: | Re: Lets Torque |
Have an "inverter" blue box on the bottom left of pic. 1phase in 3 phase out, lathe starts and then stops after 20seconds? Any spakies on here ?? |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|