I think the clue is in the LHD bit
but I may be wrong. London to Brighton is in a few weeks. Likely to be a good selection of bits there if you need a heater cable
Or wear a wooly jumper
| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| heater cable,,,,, http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=3878 |
Page 1 of 1 |
| Author: | 48pop [ April 21st, 2012, 11:45 am ] |
| Post subject: | heater cable,,,,, |
Hi Folks, is the LHD heater control cable suitable for a RHD? http://www.ecas2cvparts.co.uk/heater-ca ... p-753.html Cheers gerry |
|
| Author: | J-dub [ April 21st, 2012, 1:00 pm ] |
| Post subject: | Re: heater cable,,,,, |
I think the clue is in the LHD bit but I may be wrong. London to Brighton is in a few weeks. Likely to be a good selection of bits there if you need a heater cable Or wear a wooly jumper
|
|
| Author: | Sean [ April 21st, 2012, 1:28 pm ] |
| Post subject: | Re: heater cable,,,,, |
Jameswallace wrote: I think the clue is in the LHD bit but I may be wrong. London to Brighton is in a few weeks. Likely to be a good selection of bits there if you need a heater cable bit of a trek from Glasgow ( clue is in "location"  )just for a heater cable. 
|
|
| Author: | J-dub [ April 21st, 2012, 2:57 pm ] |
| Post subject: | Re: heater cable,,,,, |
Didn't see that Want me to have a look for you and post any findings to you? |
|
| Author: | 48pop [ April 21st, 2012, 10:06 pm ] |
| Post subject: | Re: heater cable,,,,, |
yeah, LHD was a clue, but then, why would they need to change it???? Cant see why it would need to be different? As it happens, I'm driving the length of the country next week Glasgow/manchester/gatwick/reading/newark/glasgow.....anyone e-route with a RHD (?) Cable |
|
| Author: | J-dub [ April 21st, 2012, 11:57 pm ] |
| Post subject: | Re: heater cable,,,,, |
The heater controls iirc are positioned differently and I imagine the cable routing is different |
|
| Author: | Saurus [ April 24th, 2012, 6:14 pm ] |
| Post subject: | Re: heater cable,,,,, |
I made those myself out of 1.6 mm spring wire (or 1/16") and bicycle brake cable housing. I bought 10 feet of spring wire from a local workshop for next to nothing, you can use a 5mm drill or bolt to wind those loops at the ends nicely. They work perfectly, maybe you could try this. |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|