| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| Kingpin washers/shims http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=3834 |
Page 1 of 1 |
| Author: | rustygubber [ April 5th, 2012, 10:57 pm ] |
| Post subject: | Kingpin washers/shims |
 on kingpins which washers go where,when i took the pin apart there was a single thrust washer on the top and a dust cover one plain washer and 1 thrust washer on the bottom,new kit has 2 plain washers and 1 thrust washer and a dust cover,haynes manual shows no top washer and 2 plain and 1 thrust washer on the bottom under dust cover,scratch head time 
|
|
| Author: | Russell [ April 5th, 2012, 11:01 pm ] |
| Post subject: | Re: Kingpin washers/shims |
Any help? viewtopic.php?f=7&t=1393 |
|
| Author: | rustygubber [ April 5th, 2012, 11:15 pm ] |
| Post subject: | Re: Kingpin washers/shims |
Thanks Russel,have already read that but it doesnt mention if all the shims go in the bottom or 1 at the top,cheers! |
|
| Author: | ken [ April 5th, 2012, 11:19 pm ] |
| Post subject: | Re: Kingpin washers/shims |
The photographs here do not show a shim above the arm, though. Inside the cover, the stack is plain washer, grooved thrust washer, plain washer... ken rustygubber wrote: Thanks Russel,have already read that but it doesnt mention if all the shims go in the bottom or 1 at the top,cheers! |
|
| Author: | rustygubber [ April 5th, 2012, 11:34 pm ] |
| Post subject: | Re: Kingpin washers/shims |
Thanks for reply Ken,are you saying no top washer,all three on bottom with thrust washer sandwiched in the middle of the two plain ones ? |
|
| Author: | Sean [ April 6th, 2012, 7:17 am ] |
| Post subject: | Re: Kingpin washers/shims |
NO top washer they all go at the bottom |
|
| Author: | rustygubber [ April 6th, 2012, 8:36 am ] |
| Post subject: | Re: Kingpin washers/shims |
Thanks Sean,is that the thrust washer in the middle of the 2 plain washers or at the bottom
|
|
| Author: | rustygubber [ April 6th, 2012, 8:42 am ] |
| Post subject: | Re: Kingpin washers/shims |
Thanks all,sorted now 
|
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|