Hi,offside kingpin,had alot of play seamed to be top bush,removed driveshaft and top cap missing,having prod around and stuck a tapered punch in kingpin hole to see if could get grease out anywhere else rather than top,once pumped grease gun it pushed pin out the top,now all apart and clean the top bush is badly worn ,the bottom slightly but not so bad,the kingpin looks ok with no burrs and goes through the suspension arm with the pressure of one hand,its not sloppy but not tight,measured the pin and seams about 16.98,just wondering if a standard pin kit will do or a 17,1mm oversize,not sure how tight in there they are supposed to be
