International2cvFriends.com
http://www.international2cvfriends.com/forum/

Sill to floor seatbelt mounts
http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=3744		 Page 1 of 1
Author:  meshking [ March 7th, 2012, 9:16 pm ]
Post subject:  Sill to floor seatbelt mounts
Am I going mad, or should there be a small bracket that bolts between floor and sill on a 2cv? Just behind the b post I have the rear sill thread but also there are two threaded bolts in the floors.

Anyone put me out of my misery, please?
Author:  ken [ March 7th, 2012, 9:23 pm ]
Post subject:  Re: Sill to floor seatbelt mounts
Hi Ben,
nope, you're not losing the plot, although perhaps you've misplaced the brackets. ;)

7/16" UNF bolt into the sill, 2 x M9 bolts through the floor into the reinforcement/captive nut carrier underneath the floor.

Note that the brackets are handed.

ken



meshking wrote:
Am I going mad, or should there be a small bracket that bolts between floor and sill on a 2cv? Just behind the b post I have the rear sill thread but also there are two threaded bolts in the floors.

Anyone put me out of my misery, please?
Author:  Neil [ March 7th, 2012, 9:27 pm ]
Post subject:  Re: Sill to floor seatbelt mounts
A low quality pic of the one on the YSH:

Image
Author:  ken [ March 7th, 2012, 9:35 pm ]
Post subject:  Re: Sill to floor seatbelt mounts
If you want proper low quality,
(at best priiice) I can dig out a photograph where one of the M9 bolts had been replaced with an M8, held in with seam sealer on a 4k (partial) restauration . :roll:

ken
Author:  meshking [ March 7th, 2012, 9:52 pm ]
Post subject:  Re: Sill to floor seatbelt mounts
Argh, I've misplaced the brackets! Thanks both! I've got the bolts (for the sill) ready, just not the brackets. Seam sealer?

Anyone have a set they could send to me (in return for some cash, of course!)? Uncle Roy didn't reply (yet...)
Author:  Sean [ March 7th, 2012, 10:03 pm ]
Post subject:  Re: Sill to floor seatbelt mounts
i usually replace the M9 with M10 fine 12.9 bolts you get with the VW ball joints -but they are the wrong thread for the hubs
Page 1 of 1 All times are UTC + 1 hour [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/