| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| Clutch Problem http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=3708 |
Page 1 of 1 |
| Author: | ChrisW [ February 23rd, 2012, 3:15 pm ] |
| Post subject: | Clutch Problem |
Hi All, The other day I was stuck (far from home) with a problem I have never seen before. I could not get 1st or reverse without the nasty crunch. I tried to adjust the cable but nothing doing. I got under the car and found the problem. I have an old fashioned clutch with the 3 finger activater. These fingers are held in (in out position) by small screws and 2 nuts. One of the fingers had come lose and was holding the pressure plate against the flywheel. I did manage to tighten it back after cutting a spanner to fit into gap (did not want to remove engine) and put loctite on the 2 nuts. Has anyone come over this problem before.... |
|
| Author: | J-dub [ February 23rd, 2012, 4:33 pm ] |
| Post subject: | Re: Clutch Problem |
Mine crunches into first or reverse of you dont go into 2nd or third or fourth before hand! |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|