subarupete wrote:
Hi Dave?
Paul.
| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| GS Engine http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=3691 |
Page 1 of 1 |
| Author: | subarupete [ February 16th, 2012, 2:35 pm ] |
| Post subject: | GS Engine |
Is there anybody on the forum who can help/advise about GS Engines? |
|
| Author: | Nelsthebass [ February 17th, 2012, 7:38 pm ] |
| Post subject: | Re: GS Engine |
Hi Pete I was the guy that bought that engine from you last year - btw its running well - I'm not an expert but have had to work my way around them a little - what is it you need advise on? |
|
| Author: | subarupete [ February 17th, 2012, 8:12 pm ] |
| Post subject: | Re: GS Engine |
Hi Dave? Glad the motor is OK. It appears the Distributer can be fitted two-ways ie 180 Deg in Error. If poss a photo would help. Also do you have the LHM pump? Cheers Peter |
|
| Author: | Russell [ February 17th, 2012, 8:14 pm ] |
| Post subject: | Re: GS Engine |
subarupete wrote: Hi Dave? Paul.
|
|
| Author: | Nelsthebass [ February 17th, 2012, 8:36 pm ] |
| Post subject: | Re: GS Engine |
Ha Ha - yup its Dave here Pete! Damn - Mikes got the car in Manchester so cant get a pic - Ill dig my Haynes out. As all three engines have been going in a sidewinder, I have removed the pump and blanked them off - I suspect I will have thrown the bits away! I will have to look in my parts bin tomoro for you |
|
| Author: | Nelsthebass [ February 17th, 2012, 8:48 pm ] |
| Post subject: | Re: GS Engine |
Pete - the vacuum advance should be on the top of the distributor as you look at it with the capacitor to the kerb side - as for the cap, from the typically poor pictures in Haynes, it fits with two of the HT sockets in a vertical position. Hope this helps... Paul |
|
| Author: | subarupete [ February 17th, 2012, 8:57 pm ] |
| Post subject: | Re: GS Engine |
Hi Paul, Yes that should help. Have the Haynes book, agree about the photos, to much contrast. The bit I need from the pump is the "Connecting Rod" sits on the oil pump. Also do you have any LHM parts in you bin? Cheers Peter |
|
| Author: | Nelsthebass [ February 18th, 2012, 6:50 pm ] |
| Post subject: | Re: GS Engine |
No connecting rod in me boxes I'm afraid Pete..... |
|
| Author: | subarupete [ February 18th, 2012, 7:27 pm ] |
| Post subject: | Re: GS Engine |
Thanks anyway. |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|