International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
Speedometer Wiring http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=3477 |
Page 1 of 1 |
Author: | Sean [ November 13th, 2011, 7:43 pm ] |
Post subject: | Re: Speedometer Wiring |
No all fine the bit on the left is the adjustment bit which was covered with a bit of tape The hole top centre is the holder for the bulb, which is in a small nylon plug with a lead and terminal, it may be still attached to the wiring in the rest of the loom. The terminal below that hole with the hex nut is the earth for the whole dash. the paper spots correspond to the colours code of the wire that attaches. PS" flying lead" is just a long piece of wire, loose, not bundled in with the loom the Purple conection is the 12v from ignition and is joined with the purple one for the charge/battery one The 12v goes in to the gauge and comes out the yellow one at nearer 8-10v and then goes via the cable to the fuel tank where it goes into the variable resistor then out to earth under the car. as the fuel drops the resistor increases and so the movement at the needle on the gage is less and so it points at the Empty side of the gauge |
Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |