Ok got old panel off
new panel fits (just) lol. Need to have a bit more of a play to line all the edges up - what a bugger these panels are!
| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| Rear Sweeps http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=3329 |
Page 1 of 1 |
| Author: | citroenboixm [ September 15th, 2011, 9:55 pm ] |
| Post subject: | Rear Sweeps |
Hi guys, I am |
|
| Author: | Russell [ September 15th, 2011, 10:32 pm ] |
| Post subject: | Re: Rear Sweeps |
All I'd say is fit the window to make sure it'll go in properly before you cut it, and my preference is to seam weld the join and clean it back with increasingly finer sanding flap wheels and wet and dry paper. I'd have thought using a spot welder and overlapping the panels would mean having to use filler and having a join that'd possibly crack in the future. I seem to recall that the last set of these I fitted I cut back a little from the factory edge as it didn't seem quite right, maybe only an inch or so. |
|
| Author: | citroenboixm [ September 15th, 2011, 10:43 pm ] |
| Post subject: | Re: Rear Sweeps |
Cheers Russell, Im intending on spot welding only the edges and as you say seam welding the join. Thanks for the window tip,, just need to drill out all the bloody spot welds now lol |
|
| Author: | Will2cv [ September 16th, 2011, 10:22 am ] |
| Post subject: | Re: Rear Sweeps |
What Russ said basically. Pre-fit the window glass to make sure it is all in the right place and only use filler to finish off any imperfections otherwise it will crack. Make sure you leave a good bit of metal spare on the top of the inner wing to weld the new panel to. Measure twice, cut once! |
|
| Author: | citroenboixm [ September 22nd, 2011, 7:40 pm ] |
| Post subject: | Re: Rear Sweeps |
Hi guys, nearly got this panel out. I'm having trouble separating the rear lip which makes up the edge of the boot. Am I right in thinking there is just two parallel lines of spot welds in sort of a zig zag pattern holding this on? Cheers mark |
|
| Author: | Sean [ September 22nd, 2011, 8:57 pm ] |
| Post subject: | Re: Rear Sweeps |
Might be braized as well depending on where/when its built, there are a lot of spot welded then braized joints in the shell used as much as a seal as anything |
|
| Author: | citroenboixm [ September 24th, 2011, 8:20 pm ] |
| Post subject: | Re: Rear Sweeps |
Ok got old panel off new panel fits (just) lol. Need to have a bit more of a play to line all the edges up - what a bugger these panels are!
|
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|